03-02-2014, 12:17 PM
Almost time to start putting stuff back in. I have the patch panel I made (second one) screwed in there temporarily to check the fit. I don't think it turned out too bad to have been formed by beating the flanges out over the edge of my work bench. I have to take it back out to cut the hole for the fuel tank valve. You can also see the little triangle piece I cut out by the shifter. Going to make a patch for there.
![[Image: WP_20140301_012.jpg]](https://lh6.googleusercontent.com/-GoIwEhfdlwU/UxNJPQFMNKI/AAAAAAAAA2k/_soRme53biA/w1043-h587-no/WP_20140301_012.jpg)
![[Image: WP_20140301_018.jpg]](https://lh3.googleusercontent.com/-ajF6MdQgdvE/UxNJI8otR4I/AAAAAAAAA2U/d99ZRjtQTHw/w1043-h587-no/WP_20140301_018.jpg)
![[Image: WP_20140301_024.jpg]](https://lh3.googleusercontent.com/-VWeHANcFJdE/UxNJUEs82QI/AAAAAAAAA2s/asFuuDYosJs/w1043-h587-no/WP_20140301_024.jpg)
![[Image: WP_20140301_012.jpg]](https://lh6.googleusercontent.com/-GoIwEhfdlwU/UxNJPQFMNKI/AAAAAAAAA2k/_soRme53biA/w1043-h587-no/WP_20140301_012.jpg)
![[Image: WP_20140301_018.jpg]](https://lh3.googleusercontent.com/-ajF6MdQgdvE/UxNJI8otR4I/AAAAAAAAA2U/d99ZRjtQTHw/w1043-h587-no/WP_20140301_018.jpg)
![[Image: WP_20140301_024.jpg]](https://lh3.googleusercontent.com/-VWeHANcFJdE/UxNJUEs82QI/AAAAAAAAA2s/asFuuDYosJs/w1043-h587-no/WP_20140301_024.jpg)
![[Image: WP_20140301_025.jpg]](https://lh6.googleusercontent.com/-q7mroXCGJNg/UxNJYAUNt7I/AAAAAAAAA20/2WaWYYLcbvo/w1043-h587-no/WP_20140301_025.jpg)